IS32LT3951-GRLA3-TR

驅動 Buck
狀態 Prod
Vin(V) 4.5~38
調光 PWM
文件 Eval Board
關鍵特點 1.5-Ampere PWM dimmable constant-current buck LED driver with output fault report/protect, 2uA shutdown, spread spectrum
功率晶體管 Built-in
腳位尺寸(mm) SOP-8-EP
腳位/封裝 GR = SOP
焊料類型 L = Lead-free (RoHS Compliant)
產品系列 32 = Automotive Analog and Mixed Signal
IC代碼 3951 = 3951
產品類別 LT = Lighting LED Driver
Temperature Grade A3 = Automotive temp. (-40°C to 125°C)
包裝選項 TR = Tape & Reel
外包裝 Tape on Reel

IS32LT3951-GRLA3-TR 特徵

  • Wide input voltage supply from 4.5V to 38V
  • - Withstand 40V load dump
  • True average output current control
  • 1.5A maximum output over operating temperature range
  • Cycle-by-cycle current limit
  • Dimming via direct logic input or power supply Integrated high-side MOSFET switch voltage Internal control loop compensation
  • Under-voltage lockout (UVLO) and thermal shutdown protection
  • 2μA low power shutdown
  • Spread spectrum to optimize EMI
  • Robust fault protection and reporting function:
  • - Pin-to-GND short - Component open/short faults - Adjacent pin-to-pin short - LED open/short - Thermal shutdown
  • AEC-Q100 Qualified
  • Automotive and avionic lighting
  • Daytime running lights
  • Turn/stop lights
  • Front and rear fog lights
  • Matrix headlight

概觀

The IS32LT3951 is a DC-to-DC switching converter that integrates an N-channel MOSFET to operate in a buck configuration. The device can operate from a wide input voltage between 4.5V and 38V and provides a constant current of up to 1.5A for driving a single LED or multiple series connected LEDs. The external resistor, RISET, is used to set a constant LED output current, while allowing the output voltage to be automatically adjusted for a variety of LED configurations. The IS32LT3951 operates in a fixed frequency mode during switching. There is an external resistor connected between the VCC and TON pins used to configure the on-time (switching frequency). The switching frequency is dithered for spread spectrum operation which will spread the electromagnetic energy into a wider frequency band. This function is helpful for optimizing EMI performance. A logic input PWM signal applied to the enable (EN) pin will adjust the average LED current. The LED brightness is proportional to the duty cycle of the PWM signal. True average output current operation is achieved with fast transient response by using cycle-by-cycle, controlled on-time method. The IS32LT3951 is available in an SOP-8-EP package with an exposed pad for enhanced thermal dissipation. It operates from 4.5V to 38V over the temperature range of -40°C to +125°C.