IS31LT3952-GRLS4-TR

電流 - 輸出/通道 1.5A
狀態 Prod
Vdd(V) 4.5~38
腳位數 SOP-8-EP
文件 Eval Board
驅動類型 Buck
效率(%) 95
功率晶體管 Integrated
腳位/封裝 GR = SOP
焊料類型 L = Lead-free (RoHS Compliant)
產品系列 31 = Commercial/Industrial Analog
IC代碼 3952 = 3952
產品類別 LT = Lighting LED Driver
Temperature Grade S4 = Industrial temp. (-40°C to 125°C)
包裝選項 TR = Tape & Reel
外包裝 Tape on Reel

IS31LT3952-GRLS4-TR 特徵

  • Wide input voltage supply from 4.5V to 38V
  • - Withstand 40V load dump
  • True average output current control
  • 1.5A maximum output over operating temperature range
  • Cycle-by-cycle current limit
  • Dimming via direct logic input or power supply Integrated high-side MOSFET switch voltage Internal control loop compensation
  • Under-voltage lockout (UVLO) and thermal shutdown protection
  • 2μA low power shutdown
  • Spread spectrum to optimize EMI
  • Robust fault protection:
  • - Pin-to-GND short - Component open/short faults - Adjacent pin-to-pin short - LED open/short - Thermal shutdown
  • General high brightness LED lighting
  • Architecture lighting
  • Dimmable lights

概觀

The IS31LT3952 is a DC-to-DC switching converter that integrates an N-channel MOSFET to operate in a buck configuration. The device can operate from a wide input voltage between 4.5V and 38V and provides a constant current of up to 1.5A for driving a single LED or multiple series connected LEDs. The external resistor, RISET, is used to set a constant LED output current, while allowing the output voltage to be automatically adjusted for a variety of LED configurations. The IS31LT3952 operates in a fixed frequency mode during switching. There is an external resistor connected between the VCC and TON pins used to configure the on-time (switching frequency). The switching frequency is dithered for spread spectrum operation which will spread the electromagnetic energy into a wider frequency band. This function is helpful for optimizing EMI performance. A logic input PWM signal applied to the enable (EN) pin will adjust the average LED current. The LED brightness is proportional to the duty cycle of the PWM signal. True average output current operation is achieved with fast transient response by using cycle-by-cycle, controlled on-time method. The in an SOP-8-EP package with an exposed pad for enhanced thermal dissipation. It operates from 4.5V to 38V over the temperature range of -40°C to +125°C.